ABS Indicator Malfunction
Diagnostic Instructions
Circuit/System Description
The instrument cluster turns ON the ABS indicator for 5 seconds after Vehicle in Service Mode or when the electronic brake control module detects a fault and sends a serial data message to the instrument cluster commanding the indicator ON.
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
ABS Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
- Vehicle in Service Mode.
- Verify that no DTCs are set.
- Verify the instrument cluster ABS indicator turns ON and OFF when commanding the All Indicators ON and OFF with a scan tool.
⇒ | If ABS indicator does not turn ON and OFF
|
| Replace the P16 instrument cluster. |
⇓ | If the ABS indicator turns ON and OFF
|
- Verify the ABS indicator turns OFF 5 seconds after the ignition is turned ON.
⇒ | If the ABS indicator does not turn OFF
|
| Replace the K17 electronic brake control module. |
⇓ | If the ABS indicator turns OFF
|
- All OK.
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for electronic brake control module or instrument cluster replacement, programming and setup
©© Copyright Chevrolet. All rights reserved |