Danger: Do not use a service jack in locations other than those specified to lift this vehicle. Lifting the vehicle with a jack in those other locations could cause the vehicle to slip off the jack and roll; this could cause injury or death.

Preliminary Procedure

1. Drain the coolant. Refer to Drive Motor Generator Power Inverter Module Cooling System Draining and Filling
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
3. Remove the front wheelhouse front liner on the passenger side. Refer to Front Wheelhouse Front Liner Replacement

1

Drive Motor Battery Coolant Inlet Hose Bolt

Caution: Refer to Fastener Caution in the Preface section.

Tighten
9 N·m (80 lb in)

2

Drive Motor Battery Coolant Inlet Hose Clamp

Procedure

Reposition the drive motor battery coolant inlet hose clamp using BO-38185 Hose Clamp Pliers

Special Tools

BO-38185 Hose Clamp Pliers

For equivalent regional tools, Refer toSpecial Tools

3

Drive Motor Battery Coolant Inlet Hose Quick Disconnect Fitting

4

Drive Motor Battery Coolant Inlet Hose

Tip
Replace corroded hose clamps and brackets.