To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

DTC P0C1A

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    • Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P0C1A: Drive Motor 2 Torque Delivered Performance

Circuit/System Description

Each drive motor generator is controlled by a motor control module. The motor control module constantly monitors the requested torque and the delivered torque of its respective drive motor generator. The motor control module is part of the power inverter module, also called the drive motor generator power inverter module and is not serviced separately.

Conditions for Running the DTC

    • Vehicle ON.
    • Drive motor 2 is commanded to develop torque.

Conditions for Setting the DTC

The motor control module has detected that drive motor generator torque is not being delivered as expected.

Action Taken When the DTC Sets

    • DTC P0C1A is a Type A DTC.
    • The hybrid powertrain control module requests the hybrid powertrain control module 2 to open the high-voltage contactor relays.

Conditions for Clearing the DTC

DTC P0C1A is a Type A DTC.

Diagnostic Aids

Extremely hard braking during regeneration may cause this DTC to be set in history.

Reference Information

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Circuit/System Verification

If the DTC is set, program the T6 power inverter module. If the DTC resets, replace the T6 power inverter module.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for Drive Motor Generator Power Inverter Module, also called the power inverter module, replacement, programming and set-up.

   


&#169© Copyright Chevrolet. All rights reserved