To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

DTC P1E45

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    • Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P1E45: 14 Volt Power Module Temperature Sensors 1-2 Not Plausible

Circuit/System Description

The 14 V power module, also referred to as the accessory DC power control module, constantly monitors system temperature to protect against over-heat conditions. The module also monitors the function of the temperature sensors. These sensors are internal to the 14 V power module and are not serviced separately from the control module.

Conditions for Running the DTC

The vehicle is ON.

Conditions for Setting the DTC

Sensor 1 and sensor 2 values vary by greater than 30°C.

Action Taken When the DTC Sets

DTC P1E45 is a Type C DTC.

Conditions for Clearing the DTC

DTC P1E45 is a Type C DTC.

Reference Information

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Circuit/System Verification

If the DTC is set, program the K1 14V power module. If the DTC resets, replace the K1 14 V power module.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for Accessory DC Power Control Module, also called the 14 V power module, replacement, programming and set-up.

   


&#169© Copyright Chevrolet. All rights reserved