To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

DTC P1E38

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    • Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P1E38: Auxiliary Transmission Fluid Pump Inverter Supply Voltage Circuit

Circuit/System Description

The power inverter motor, often referred to as the drive motor generator power inverter module, contains three motor control modules and the hybrid powertrain control module. Two of the motor control modules operate their respective drive motor generator based upon power inverter module commands. The third motor control module controls the auxiliary transmission fluid pump motor. The hybrid powertrain control module and the motor control modules share the power inverter module ignition voltage circuit, battery voltage circuits and chassis earth.

Conditions for Running the DTC

Vehicle is ON or Charge Mode is active.

Conditions for Setting the DTC

The control module does not detect voltage at the insulated gate bipolar transistor bias power supply.

Action Taken When the DTC Sets

DTC P1E38 is a Type A DTC.

Conditions for Clearing the DTC

DTC P1E38 is a Type A DTC.

Reference Information

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Circuit/System Verification

If the DTC is set, program the T6 power inverter module. If the DTC resets, replace the T6 power inverter module.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for Drive Motor Generator Power Inverter Module, also called the power inverter module, replacement, programming and set-up.

   


&#169© Copyright Chevrolet. All rights reserved