To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Traction Control/Stability Control Indicator Malfunction

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    • Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Circuit Description

The instrument cluster illuminates the Stabilitrak indicator during the instrument cluster bulb check or when the electronic brake control module detects a fault and sends a serial data message to the instrument cluster commanding the indicator ON.

Reference Information

Schematic Reference

Antilock Brake System Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

ABS Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

When the ignition is turned ON, the stabilitrak indicator lamp should illuminate, then after 5 seconds it should turn OFF.

  1. Vehicle in Service Mode.
  2. Verify the instrument cluster traction control/stability control-active indicator turns ON and OFF when commanding the All Indicators ON and OFF with a scan tool.
  3. If the indicator does not turn ON and OFF
        Replace the P16 instrument cluster.
    ⇓   If the indicator turns ON and OFF
  4. All OK.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the repair.

Control Module References for instrument cluster replacement, programming and setup

   


&#169© Copyright Chevrolet. All rights reserved