Volt

DTC C0299 or C12FF

The electronic brake control module uses inputs from the brake master cylinder piston position sensor and the brake pedal position sensor to determine when the brake pedal is being applied and with how much force. These inputs determine the driver's braking intent which is used to control the amount of pressure applied to the wheels.

Schematic Reference

Antilock Brake System Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

ABS Description and Operation

Electrical Information Reference

Scan Tool Reference

Control Module References for scan tool information

Note: The 12 V battery must be able to maintain a charge during this brake sensor performance procedure. It is recommended that a charger/maintainer or equivalent be used to maintain proper battery voltage during this procedure.

1. Vehicle in Service Mode.
2. Place the transmission in PARK.

Note: Do not depress the brake pedal during the Electronic Brake Control Module Learn.

3. Perform the Electronic Brake Control Module Learn procedure with a scan tool.

Note: To ensure the complete brake modulator and high pressure accumulator pressure relief procedure is allowed to occur; the brake controller must see 1 pedal apply with the propulsion system enabled, followed by a proper shutdown without applying the brake pedal.

4. Vehicle ON, apply and release the brake pedal.

Note: Vehicle OFF, without applying the brake pedal ensure the brake modulator and high pressure accumulator pressure relief occurs. This process will take approximately 1-3 minutes.

5. Vehicle OFF, without applying the brake pedal, remove the remote keyless entry transmitter and close all of the vehicle doors.
6. Wait approximately 1-3 minutes until the brake modulator and the high pressure accumulator pressure relief is complete and the vehicle powers down. Vehicle ON, brakes not applied
7. Verify the scan tool parameters listed below are within the specified range:

•	Brake Controls Brake Pedal Position Sensor 5 V Supply Voltage - Between 4.75-5.25 V.

•	Brake Controls Brake Pedal Position Sensor Circuit 1 - Between 1.4-1.7 V

•	Brake Controls Brake Pedal Position Sensor Circuit 2 - Between 58 78%

⇒	If any parameter is not within the specified range

Refer to DTC C029C, C120C, C129A-C129F, C12B1, or C12F8 .

⇓	If all parameters are within the specified range

8. Vehicle ON, brakes not applied.
9. Verify the scan tool parameters listed below are less the specified range:

•	Brake Master Cylinder Pressure Sensor - Less than 100 kPa (15 psi)

•	Brake Pressure Sensor - Less than 100 kPa (15 psi)

•	High Pressure Accumulator Sensor - Less than 800 kPa (116 psi)

⇒	If any parameter is greater than the specified range

Replace the Q5 brake pressure modulator.

⇓	If all parameters are less than the specified range

10. Perform a brake hydraulic check, refer to Brake Hydraulic and Assist System Diagnosis .

⇒	If the brake hydraulic system test does not pass

Repair as necessary.

⇓	If all parameters are less than the specified range

11. Replace the Q5 brake pressure modulator.
12. Verify the DTC does not set while operating the vehicle under the Conditions for Running the DTC.

⇒	If the DTC sets

Replace the K17 electronic brake control module.

⇓	If the DTC does not set

13. All OK.

Perform the Diagnostic Repair Verification after completing the repair.