To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Charger Door Ajar Indicator Malfunction

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    • Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Diagnostic Fault Information

Circuit

Short to Ground

Open/High Resistance

Short to Voltage

Signal Performance

Charge Port Door Sensor Signal

P0CCC 00

P0CCE 00

P0CCF 00

--

Ground

--

P0CCE 00

--

--

Circuit/System Description

The hybrid powertrain control module 2 provides a 5V signal through a pull-up resistor to the Charge Port Door Position Sensor Circuit. The other end of the Charge Port Door Position Sensor Circuit is connected to the Charge Port Door Position Switch. The hybrid powertrain control module 2 monitors the voltage on the Charge Port Door Position Sensor Circuit. In normal operation, the hybrid powertrain control module 2 sends a serial data message to the driver information centre in the instrument panel cluster to display the Charge Door Open message.

Reference Information

Schematic Reference

Plug-In Charging Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Charge Port Door Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

Vehicle in Service Mode, observe the scan tool Charge Port Door parameter while opening and closing the charge port door, the value should change between Open and Closed.

Circuit/System Testing

  1. Vehicle OFF, disconnect the harness connector at the B197 charge port door position switch.
  2. Test for less than 10 Ω between the ground circuit terminal C and ground.
  3. If greater than the specified range, test the ground circuit for an open/high resistance.
  4. Vehicle in Service Mode, test for 4.75-5.25 V between the signal circuit terminal A and ground.
  5. If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K114B hybrid powertrain control module 2.
    If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the K114B hybrid powertrain control module 2.
  6. If all circuits test normal, test or replace the B197 charge port door position switch.

Component Testing

  1. Vehicle OFF, disconnect the harness connector at the B197 charge port door position switch.
  2. Test for 180 Ω--190 Ω between the signal terminal A and the ground terminal C with the switch in the open position.
  3. If not within the specified range, replace the B197 charge port door position switch.
  4. Test for 2040 Ω--2065 Ω between the signal terminal A and the ground terminal C with the switch in the closed position.
  5. If not within the specified range, replace the B197 charge port door position switch.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

    •  Charge Port Door Ajar Indicator Switch Replacement
    • Control Module References for the hybrid powertrain control module 2 replacement, programming and setup
   


&#169© Copyright Chevrolet. All rights reserved