To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

DTC U180B

Diagnostic Instructions
    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    • Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC U180B 00: Battery Energy Control Module High-Speed GMLAN Communication Bus Off

Circuit/System Description

The high-speed GMLAN serial data circuits are serial data buses used to communicate information between the control modules. The high-speed GMLAN serial data circuits connect directly to the data link connector (DLC) for programming purposes.

This diagnostic is used to check the high-speed GMLAN communication bus status.

Conditions for Running the DTC
    • Vehicle ON.
    • The system voltage is at least 9 V.

Conditions for Setting the DTC

The control module setting the DTC has attempted to establish communications on the serial data circuits for more than 1.4 seconds without success.

Action Taken When the DTC Sets

The DTC U180B is a type B DTC.

Conditions for Clearing the DTC

The DTC U180B is a type B DTC.

Circuit/System Verification

Diagnosis is accomplished using the symptom. Refer to Scan Tool Does Not Communicate with High Speed GMLAN Device .

   


&#169© Copyright Chevrolet. All rights reserved