To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Water Pump Belt Replacement

Removal Procedure


    2444158
  1. Remove the air cleaner assembly (1). Refer to Air Cleaner Assembly Replacement
  2. Install the engine support fixture. Refer to Engine Support Fixture

  3. 2523201
  4. Remove the right engine mount (1). Refer to Engine Mount Replacement - Right Side

  5. 2523203
  6. Remove the right engine mount bracket (1). Refer to Engine Mount Bracket Replacement - Right Side

  7. 2523200
  8. Cut the water pump belt (1) with a appropriate cutting tool as shown.
  9. Remove and discard the water pump belt.

Installation Procedure


    2523194

    Note: Position the water pump pulley (2) as shown. The position of the pulley bolts (3) will help prevent the belt from catching on the bolts and provide ease of installation.

  1. Position a NEW water pump belt (1) on the crankshaft pulley and water pump pulley (2) as shown.
  2. Note: Using the thumb of your free hand, hold the water pump belt on the water pump pulley. Push the belt onto the pulley with your thumb while rotating the crankshaft pulley.

  3. Using a socket and ratchet on the crankshaft pulley bolt, rotate the crankshaft in the direction of the arrow until the belt is fully installed on the water pump pulley.
  4. After the belt is on the water pump pulley, rotate the crankshaft an additional complete revolution and ensure the water pump belt is fully seated on the crankshaft and water pump pulleys.

  5. 2523203
  6. Install the right engine mount bracket (1). Refer to Engine Mount Bracket Replacement - Right Side .

  7. 2523201
  8. Install the right engine mount (1). Refer to Engine Mount Replacement - Right Side .
  9. Remove the engine support fixture.

  10. 2444158
  11. Install the air cleaner assembly (1). Refer to Air Cleaner Assembly Replacement
   


© Copyright Chevrolet. All rights reserved