To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection

Special Tools

GE-41623 Cooler Quick Connect Tool

For equivalent regional tools, refer to Special Tools .

Removal Procedure


    1195053
  1. Install the GE-41623 cooler quick connect tool onto the transmission oil cooler (TOC) pipe.

  2. 1195054
  3. Slide the GE-41623 cooler quick connect tool toward the TOC pipe fitting.

  4. 1195056

    Note: Rotate the GE-41623 cooler quick connect tool to engage the TOC pipe fitting retainer slots.

    The GE-41623 cooler quick connect tool should be nearly flush with the fitting.

  5. Connect the GE-41623 cooler quick connect tool onto the TOC pipe fitting.

  6. 1195059
  7. Rotate the GE-41623 cooler quick connect tool until the retainer clip (1) rises above the fitting retainer seat.

  8. 1195062
  9. Pull back on the TOC pipe to disengage the pipe from the TOC pipe fitting.
  10. Remove the GE-41623 cooler quick connect tool from the TOC pipe.

Installation Procedure


    1195424

    Note: Inspect the TOC pipe fitting and retaining clip for signs of wear or damage. Replace the components if necessary.

  1. Install the TOC pipe into the TOC pipe fitting.
  2. A distinct snap should be heard or felt when assembling the TOC pipe to the fitting.

  3. To ensure the cooler line is properly installed, give the cooler pipe a gentle pull.
   


© Copyright Chevrolet. All rights reserved