To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

DTC P0A80

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    • Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P0A80: Replace Hybrid/EV Battery Pack

Circuit/System Description

The battery energy control module will determine when a fault condition is present. Diagnostics and system status are communicated from the battery energy control module to hybrid powertrain control module 2 through serial data. The hybrid powertrain control module 2 is the host controller for diagnostic trouble code information.

Conditions for Running the DTC

    • Vehicle in Service Mode.
    • Hybrid battery temperature is greater than -7°C (19.4°F)
    • Hybrid battery state of charge is between 20% and 90%
    • Battery voltage and current is varying. Requires more than 10 minutes of city driving.
    • None of the following DTCs are set: P0A9C, P0A9D, P0A9E, P0ABB, P0ABC, P0ABD, P0AC1, P0AC2, P0AC6, P0AC7, P0AC8, P0ACB, P0ACC, P0ACD, P0AE9, P0AEA, P0AEB, P0AF8, P0B13, P0B10, P0B11, P0BC3, P0BC4, P0BC5, P0C34, P0C35, P0C36, P0C7D, P0C7E, P0C7F, P0C82, P0C83, P0C84, P0C89, P0C8A, P0C8B, P0C8E, P0C8F, P0C90, P0C93, P0C94, P0C95, P0C98, P0C99, P0C9A, P0CA9, P0CAA, P0CAB, P0CAE, P0CAF, P0CB0, P0CB3, P0CB4, P0CB5, P0CB8, P0CB9, P0CBA, P1A07, P1E8E, P1E8F, P1E90, P1E91, P1E93, P1E94, P1E95, P1E96, P1E97, P1E99, P1E9A, P1E9B, P1E9C, P1E9D, P1E9F, P1EA0, P1EA1, P1EA2, P1EA3, P1EA5, P1EB1, P1EB2, P1EB3, P1EB4, P1EB5, P1EBA, P1EBB, U2401, U2603, U2604, U2605, U2606, U0111 and U185A

Conditions for Setting the DTC

    • Battery voltage and current is varying. Requires more than 10 minutes of city driving.
    • Hybrid Battery Calculated Resistance is greater than 1 Ω.

Action Taken When the DTC Sets

DTC P0A80 is a type B DTC.

Conditions for Clearing the DTC

DTC P0A80 is a type B DTC.

Reference Information

Schematic Reference

Hybrid Energy Storage Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Drive Motor Battery System Description

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Control Module References for scan tool information

Special Tools

EL-48900 HEV Safety Kit

For equivalent regional tools, refer to Special Tools .

Circuit/System Verification

Danger: Any hybrid/EV battery pack replacement shall be performed by High-Voltage Qualified Technicians only. The replacement procedure can be found in the service instruction and must be strictly followed at all times. The High-Voltage Qualified Technician is responsible for adherence to the manufacturer's service instructions as well as current national legal regulations. If the hybrid/EV battery pack needs to be replaced contact the Technical Assistance Centre for further instructions prior to removal of the battery pack.

  1. Verify that no other DTCs are set.
  2. If any other DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .
  3. If DTC P0A80 is set, replace the A4 hybrid/EV battery pack.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the repair.

    •  Drive Motor Battery Replacement and Shipping Preparation
    • Control Module References for battery energy control module replacement and hybrid battery interface control modules 1-4, programming and set-up for the hybrid/EV battery pack replacement.
   


&#169© Copyright Chevrolet. All rights reserved