DTC P1EB1
Diagnostic Instructions
DTC Descriptor
DTC P1EB1 00: Hybrid/EV Battery Interface Control Module Software Incompatible
Circuit/System Description
This is the software incompatibility issue between the hybrid battery interface control modules and the battery energy control module. No external circuits are involved.
Conditions for Running the DTC
• | The system voltage is at least 9 V. |
• | DTC U2401, U2603, U2604, U2605 or U2606 is not set. |
Conditions for Setting the DTC
• | Any one of the hybrid battery interface control module software revision does not match. |
• | Battery energy control module software and hybrid battery interface control module software are incompatible. |
Action Taken When the DTC Sets
• | Slave data that is incompatible with the battery energy control module software is set to Invalid, 0 V and -40°C (-40°F). |
• | DTC P1EB1 is a type A DTC. |
Conditions for Clearing the DTC
DTC P1EB1 is a type A DTC.
Diagnostic Aids
If stored only as a history DTC and not retrieved as a current DTC, do not replace the control module.
Circuit/System Verification
If the DTC P1EB1 is set, program the K16 battery energy control module. This DTC should not reset.
⇒ | If the DTC resets without other DTCs set, replace the A4 hybrid/EV battery pack. |
⇒ | If the DTC resets along with any of the DTCs P1EB2, P1EB3, P1EB4, or P1EB5 set, refer to DTC P1EB2-P1EB5 . |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
©© Copyright Chevrolet. All rights reserved |