To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Clear Secured High-Voltage DTCs

Clear Secured High-Voltage DTCs

The Hybrid/EV Battery Pack Clear Secured High Voltage DTCs procedure must be completed when the following components are replaced:

    • Hybrid/EV Powertrain Control Module 2
    • Hybrid/EV Battery Energy Control Module
    • Hybrid/EV Battery Interface Control Module
    • Hybrid/EV Battery Pack

The Hybrid/EV Powertrain Control Module 2 Clear Secured High Voltage DTCs procedure can be completed with a scan tool using the following steps:

  1. Install the scan tool to the data link connector.
  2. Note: A command reject may appear on the scan tool after the first Hybrid/EV Battery Pack Clear Secured High Voltage DTCs request. Ignore this command reject.

  3. Vehicle in Service Mode, select Hybrid/EV Battery Pack Clear Secured High-Voltage DTCs in the Hybrid/EV Powertrain Control Module 2 Control Functions list.
  4. Follow the scan tool directions to complete the procedure.
  5. Vehicle OFF and all vehicle systems OFF. It may take up to 2 minutes for all vehicle systems to power down.
  6. Vehicle in Service Modeselect Hybrid/EV Battery Pack Clear Secured High Voltage DTCs in the Hybrid/EV Powertrain Control Module 2 Control Functions list.
  7. Follow the scan tool directions to complete the procedure.
  8. Clear any DTCs that may be set.
   


&#169© Copyright Chevrolet. All rights reserved