To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Front Bumper Fascia Removal and Installation - Volt


2393998

Callout

Component Name

Preliminary Procedures

  1. Remove the front end panel outer deflector. Refer to Front End Panel Outer Deflector Replacement : Volt → Ampera .
  2. Remove the front compartment front sight shield. Refer to Front Compartment Front Sight Shield Replacement : Volt → Ampera .
  3. Remove the windscreen washer solvent container filler tube. Refer to Windscreen Washer Solvent Container Filler Tube Replacement .
  4. Remove the side four front screws from the front wheelhouse liners. Refer to Front Wheelhouse Front Liner Replacement .

1

Front Bumper Fascia Upper Push-In Retainer (Qty: 2)

2

Front Bumper Fascia Upper Screw (Qty: 4)

Caution : Refer to Fastener Caution in the Preface section.

Tighten
3 N·m (27 lb in)

3

Front Bumper Fascia Lower Screw (Qty: 2)

Tighten
3 N·m (27 lb in)

4

Front Bumper Fascia Lower Push-In Retainer (Qty: 4)

5

Front Bumper Fascia

Procedure

  1. Carefully push a small nylon wedge between the fascia and the front fascia retainers. Insert a small flat-bladed tool into the fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the fascia from the front fascia retainers of the wing.
  2. Disconnect any electrical connectors.
  3. Transfer any parts as needed.
   


© Copyright Chevrolet. All rights reserved