Preliminary Procedures

1. Remove the front bumper fascia. Refer to Front Bumper Fascia Removal and Installation : Volt → Ampera .
2. Remove the front bumper lower fascia centre grille. Refer to Front Bumper Lower Fascia Centre Grille Replacement : Ampera .

1

Front Bumper Upper Fascia Screw (Qty: 2)

Caution : Refer to Fastener Caution in the Preface section.

Procedure

1. Carefully push a small nylon wedge between the lower fascia and the upper fascia. Insert a small flat-bladed tool into the fascia slot and depress the tabs one at a time and pull on the upper fascia at the same time to gradually remove the upper fascia from the lower fascia.
2. Transfer parts as needed.

Tighten
2.5 N·m (22 lb in)

2

Front Bumper Upper Fascia