DTC U2103
Diagnostic Instructions
DTC Descriptor
DTC U2103 00: Fewer Controllers On Than Programmed
Circuit Description
Control modules connected to the GMLAN serial data circuits monitor for serial data communications during normal vehicle operation. Operating information and commands are exchanged among the control modules. The control modules have programmed information about what messages are needed to be exchanged on the serial data circuits, for each virtual network. The messages are also supervised and some periodic messages are used by the receiver module as an availability indication of the transmitter module.
DTC U2103 will set when fewer modules are detected on the bus before the control modules can learn the other control module IDs. If the communication bus is opened, or if the control module power supply is lost when the vehicle is in the OFF power mode, and then placed in the ON power mode, U2103 will set in specific control modules.
Conditions for Running the DTCs
| • | Voltage supplied to the control modules is in the normal operating voltage range. |
| • | The vehicle power mode requires serial data communication to occur. |
| • | The DTC U2100 does not have a current status. |
Conditions for Setting the DTC
A supervised periodic message that includes the transmitter module availability has not been received.
Action Taken When the DTC Sets
The control module uses a default value for the missing parameter.
Conditions for Clearing the DTC
| • | A current DTC clears when the malfunction is no longer present. |
| • | A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction. |
Diagnostic Aids
| • | An intermittent condition is likely to be caused by a short on the GMLAN serial data circuits. Use the DTC U0100-U02FF procedure in order to isolate an intermittent condition. |
| ©© Copyright Chevrolet. All rights reserved |
