To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

DTC C0569

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    • Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC C0569 00: System Configuration Malfunction

Circuit/System Description

If the tyre type and pressure information is not entered with the scan tool during the body control module (BCM) setup, the tyre pressure monitor system indicator icon on the instrument cluster will flash for 1 min. and then remain illuminated after the power switch is cycled ON and the instrument cluster bulb check is complete. If equipped, the driver information center will also display a service tire monitor type message. Under these circumstances, DTC C0569 will be set and the tire type and pressure information will need to be entered for the system to function correctly.

Conditions for Running the DTC

Vehicle ON or Vehicle in Service Mode.

Conditions for Setting the DTC

The tyre type and pressure information is not entered into the BCM during programming and setup.

Action Taken When the DTC Sets

    • The tyre pressure monitor system indicator icon on the instrument cluster flashes for 1 min. and then remains illuminated after the power switch is cycled ON and the instrument cluster bulb check is complete.
    • If equipped, the driver information center displays a service tire monitor type message.

Conditions for Clearing the DTC

A current DTC will clear when the BCM has undergone the tyre type and pressure selection setup procedure and 1 power switch cycle has occurred.

Diagnostic Aids

A newly replaced BCM will set DTC C0569 after programming on its initial power switch ON cycle if the module setup information has not been entered.

Reference Information

Schematic Reference

Tire Pressure Monitoring System Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Tyre Pressure Monitor Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

  1. Vehicle in Service Mode.
  2. Enter the Tyre Type and Pressure information with a scan tool into the K9 body control module. Refer to Vehicle Certification, Tyre Placard, Anti-Theft, and Service Parts ID Label .
  3. Vehicle OFF then Vehicle in Service Mode.
  4. Verify DTC C0569 is not set.
  5. If the DTC is set
        Replace the K9 body control module.
    ⇓   If the DTC is not set.
  6. All OK.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the repair.

Control Module References for BCM replacement, programming, and setup.

   


&#169© Copyright Chevrolet. All rights reserved