Preliminary Procedures

1. Ensure that the steering wheel and the front wheels are in the straight ahead position.
2. Remove the steering column opening lower filler. Refer to Steering Column Opening Lower Filler Replacement .
3. With your foot off of the brake pedal and the shift lever in the PARK position, press the ignition and start switch once. This will place the ignition system in the ACCESSORY (ACC) mode and unlock the steering column for 5 minutes.
4. Turn the steering wheel in order to verify the steering column is not locked.
5. Disconnect any electrical connectors as necessary.
6. With your foot off of the brake pedal and the shift lever in the PARK position, press the ignition and start switch once. This will place the ignition system in the OFF mode. With the electrical connector disconnected, the steering column lock module will remain in the unlocked position.

1

Steering Column Lock Control Module Bolt (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Procedure

Note: The 2 steering column lock control module bolts on the forward end of the steering column lock control module are shear bolts.

1. Use any of the following common tools in order to remove the bolts:

•	An angle grinder and a screwdriver

•	A hammer and a chisel

•	A screw extractor

•	A centre punch

2. Discard the old bolts.
3. Install 2 NEW bolts and tighten until the bolt heads break off.

2

Steering Column Lock Control Module Bolt (Qty: 2)

Note: The 2 steering column lock control module bolts on the left and right sides of the steering column lock control module are standard bolts.

Tighten
9.5 N·m (84 lb in)

3

Steering Column Lock Control Module

Procedure

1. Disconnect any electrical connectors as necessary.
2. After installation is complete, programme and setup the steering column lock control module. Refer to Control Module References .