To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Heater Inlet Hose Replacement


2391652

Callout

Component Name

Danger: Always perform the High Voltage Disabling procedure prior to servicing any High Voltage component or connection. Personal Protection Equipment (PPE) and proper procedures must be followed.

The High Voltage Disabling procedure will perform the following tasks:

   • Identify how to disable high voltage.
   • Identify how to test for the presence of high voltage.
   • Identify conditions under which high voltage is always present and personal protection equipment (PPE) and proper procedures must be followed.
Failure to follow the procedures exactly as written may result in serious injury or death.

Preliminary Procedure

  1. Disable the high voltage system. Refer to High Voltage Disabling and High Voltage Enabling .
  2. Drain the coolant. Refer to Cooling System Draining and Filling .
  3. Remove the air cleaner resonator outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  5. Unclip from heater water auxiliary pump inlet hose.

1

Heater Inlet Hose Clamp

Procedure

Reposition the heater inlet hose clamp using BO-38185 pliers

Special Tools

BO-38185 Hose Clamp Pliers

For equivalent regional tools, refer to Special Tools .

2

Heater Inlet Hose Quick Connect Fitting

3

Heater Inlet Hose

Note: Replace corroded hose clamps and brackets.

   


&#169© Copyright Chevrolet. All rights reserved