To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Front Seat Belt Anchor Plate Tensioner Replacement


2413086

Callout

Component Name

Warning: Refer to SIR Warning in the Preface section.

Warning: Refer to SIR Seatbelt Pretensioner Handling Warning in the Preface section.

Warning: In order to prevent accidental deployment and the risk of personal injury, do not dispose of an undeployed inflatable restraint seat belt pretensioner as normal shop waste. Undeployed seat belt pretensioners contain substances that could cause severe illness or personal injury if their sealed containers are damaged during disposal. Use the following deployment procedures to safely dispose of an undeployed seat belt pretensioner. Failure to observe the following disposal methods may be a violation of federal, state, or local laws.

Preliminary Procedures

  1. Move the front seat to the full forward and full up position.
  2. Disable the SIR. Refer to SIR Disabling and Enabling .
  3. Remove the driver or passenger seat cushion closeout cover. Refer to Driver or Passenger Seat Cushion Closeout Cover Replacement .

1

Front Seat Belt Anchor Plate Tensioner Cover Assembly

2

Front Seat Belt Anchor Plate Tensioner Fastener

Caution: Refer to Fastener Caution in the Preface section.

Tighten
7.5 N·m (66 lb in)

3

Front Seat Belt Anchor Plate Tensioner Assembly Fastener

Tighten
45 N·m (33 lb ft)

4

Front Seat Belt Anchor Plate Tensioner Assembly

Procedure

Disconnect the electrical connector.

   


© Copyright Chevrolet. All rights reserved