To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

DTC P0601-P0604 or P0606 - Hybrid Powertrain Control Module 2

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    • Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors

DTC P0601 00: Control Module Read Only Memory Performance

DTC P0602 00: Control Module Not Programmed

DTC P0603 00: Control Module Long Term Memory Reset

DTC P0604 00: Control Module Random Access Memory Performance

DTC P0606 00: Control Module Processor Performance

Circuit/System Description

This diagnostic applies to internal microprocessor integrity conditions within the control module. This diagnostic also addresses if the control module is not programmed. The control module monitors its ability to read and write to the memory. It also monitors a timing function. No external circuits are involved.

Conditions for Running the DTC

    • Vehicle ON.
    • The system voltage is at least 7 V.

Conditions for Setting the DTC

The control module detects an internal malfunction or incomplete programming.

Action Taken When the DTC Sets

    • DTCsP0601, P0602, P0603, P0604, and P0606 are Type A DTCs.
    • The high-voltage contactor relays may open.

Conditions for Clearing the DTC

DTCsP0601, P0602, P0603, P0604, and P0606 are Type A DTCs.

Diagnostic Aids

DTC P0606 may set in Hybrid Powertrain Control Module 2 due to other faults. Do not replace the Hybrid Powertrain Control Module 2 until other DTCs are diagnosed first.

Circuit/System Verification

Verify that DTC P0601, P0602, P0603, P0604, or P0606 is not set.

If DTC P0601, P0602, P0603, P0604, or P0606 is set with other DTCs set, diagnose all other DTCs first. Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
If the DTC P0601, P0602, P0603, P0604, or P0606 is set without other DTCs set, refer toDTC P0601-P0604, P0606, or P062F .

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for control module replacement, programming and setup

   


© Copyright Chevrolet. All rights reserved