Volt |
||||||||
|
|
• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
When the vehicle is turned ON, the parking assist control module receives the vehicle identification number (VIN) from the body control module. The parking assist control module will compare the VIN received to the VIN stored in memory.
Ignition voltage is between 9-16 V.
The VIN stored in the parking assist control module does not match the received VIN.
• | The parking assist is disabled. |
• | The driver information centre displays SERVICE PARK ASSIST. |
The VIN stored in the parking assist control module matches the VIN stored in the body control module.
Object Detection Description and Operation : UVC → UD5
Control Module References for scan tool information
Vehicle in Service Mode, program the K41 Front and Rear Parking Assist Control Module and verify the DTC does not reset.
⇒ | If the DTC is reset, replace the K41 Front and Rear Parking Assist Control Module. |
Perform the Diagnostic Repair Verification after completing the repair.
Control Module References for parking assist control module replacement, programming and set-up
©© Copyright Chevrolet. All rights reserved |