To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Brake Control Brake Pedal Position Sensor Replacement

Removal Procedure

  1. Disconnect the brake control brake pedal position sensor electrical connector.

  2. 2634918
  3. Remove the brake control brake pedal position sensor bolt (1).

  4. 2634921
  5. Remove the brake control brake pedal position sensor (1).

Installation Procedure


    2634921
  1. Align the locating pin on the brake control brake pedal position sensor (1) to the hole on the brake pedal assembly bracket.
  2. Ensure the brake control brake pedal position sensor fork is properly located on the brake pedal pin.
  3. Caution: Refer to Fastener Caution in the Preface section.


    2634918
  4. Install the brake control brake pedal position sensor bolt (1) and tighten to 9 N·m (80 lb in).
  5. Connect the brake control brake pedal position sensor electrical connector.
  6. Perform the Diagnostic System Check - Vehicle .
   


© Copyright Chevrolet. All rights reserved