To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Windscreen Wiper Motor Replacement


2382102

Callout

Component Name

Preliminary Procedures

  1. Open and suitably support the bonnet assembly.
  2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  3. Remove the front suspension strut housing brace. Refer to Front Suspension Strut Housing Brace Replacement .

1

Windscreen Wiper Module Bolt (Qty: 3)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
9 N·m (80 lb in)

2

Windscreen Wiper Transmission Assembly

Procedure

  1. Lift the front edge of the assembly and pull slightly forward in order to disengage the centre support from the backside of the plenum.
  2. Disconnect the electrical connection from the windscreen wiper motor.
  3. Remove the transmission assembly from the plenum.
  4. Remove the windscreen wiper motor. Refer to Windscreen Wiper Motor Replacement .
   


© Copyright Chevrolet. All rights reserved