Volt

Transmission Control Replacement

Danger: Always perform the High Voltage Disabling procedure prior to servicing any High Voltage component or connection. Personal Protection Equipment (PPE) and proper procedures must be followed.

The High Voltage Disabling procedure will perform the following tasks:

•	Identify how to disable high voltage.

•	Identify how to test for the presence of high voltage.

•	Identify condition under which high voltage is always present and personal protection equipment (PPE) and proper procedures must be followed.

Failure to follow the procedures exactly as written may result in serious injury or death.
1. Disable the high voltage system. Refer to High Voltage Disabling .
2. Remove the front floor console. Refer to Front Floor Console Replacement .



3. Slide the shift cable retaining clip (1) toward the front of the vehicle.
4. Disconnect the shift cable (2) from the shift control actuator pin (3).
5. Slide the shift cable (2) upward to remove from shift control base (4).



6. Disconnect the electrical connector (1) from the shift control assembly.
7. Disconnect the wiring harness retainers (2) from the shift control assembly.
8. Remove the inflatable restraint sensing and diagnostic module. Refer to Inflatable Restraint Sensing and Diagnostic Module Replacement .



9. Remove the four fasteners (1).
10. Remove the shift control assembly from the instrument panel tie bar assembly.

1. Install the shift control assembly to the instrument panel tie bar assembly.

Caution: Refer to Fastener Caution in the Preface section.




2. Install the shift control assembly fasteners (1) and tighten to 10 N·m (89 lb in).



3. Install the electrical connector (1) to the shift control assembly.
4. Install the wiring harness retainers (2) to the shift control assembly.



5. Install the shift cable (2) in the shift control base (4).
6. Slide the shift cable retaining clip (1) toward the rear of the vehicle.
7. Connect the shift cable (2) to the shift control actuator pin (3).
8. Install the inflatable restraint sensing and diagnostic module. Refer to Inflatable Restraint Sensing and Diagnostic Module Replacement .
9. Install the front floor console. Refer to Front Floor Console Replacement .
10. Check transmission for proper operation. If necessary, adjust shift cable. Refer to Range Selector Lever Cable Adjustment .

Danger: Always perform the High Voltage Disabling procedure prior to servicing any High Voltage component or connection. Personal Protection Equipment (PPE) and proper procedures must be followed.

The High Voltage Disabling procedure will perform the following tasks:

•	Identify how to disable high voltage.

•	Identify how to test for the presence of high voltage.

•	Identify condition under which high voltage is always present and personal protection equipment (PPE) and proper procedures must be followed.

Failure to follow the procedures exactly as written may result in serious injury or death.
11. Enable the high voltage system. Refer to High Voltage Enabling .