Cruze

Fuel Injection Pump Replacement

Special Tools

EN-6015 Fuel Line Plug Kit

For equivalent regional tools, refer to Special Tools .

1. Remove the timing belt. Refer to Timing Belt Replacement .
2. Remove the fuel pump drive pulley. Refer to Fuel Injection Pump Drive Pulley Removal .
3. Remove the fuel feed hose. Refer to Fuel Hose Replacement - Fuel Injection Pump to Fuel Feed Block .



4. Remove the hose clamp (1).
5. Remove the hose (3) from the fuel injection pump.
6. Install the EN-6015 plug to seal the hose and the fuel injection pump.
7. Remove the intake manifold. Refer to Inlet Manifold Replacement .



8. Remove the 3 fuel pump bolts (2).
9. Remove the fuel pump (1).

Note: Do not blow air with an air gun onto injection pump. If contaminated, wipe clean with an oil paper.

1. Install the fuel pump (1).

Caution: Refer to Fastener Caution in the Preface section.

2. Install the 3 fuel pump bolts (2) and tighten to 30 N·m (23 lb ft).
3. Install the inlet manifold. Refer to Inlet Manifold Replacement .
4. Remove the EN-6015 plug.



5. Install the hose to the fuel injection pump (3).
6. Install the hose clamp (1).
7. Install the fuel feed hose. Refer to Fuel Hose Replacement - Fuel Injection Pump to Fuel Feed Block .
8. Install the fuel pump drive pulley. Refer to Fuel Injection Pump Drive Pulley Installation .
9. Install the timing belt. Refer to Timing Belt Replacement .