To the top of the document
Cruze
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Engine Coolant Fan Shroud Replacement — LDE, LLU, LUJ, LUW, LXT, LXV, L2W, 2HO-AT

Removal Procedure
  1. Disconnect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Drain the cooling system. Refer to Cooling System Draining and Filling .
  4. Remove the radiator outlet hose. Refer to Radiator Outlet Hose Replacement : 2.0L Diesel LNP → LDD, LUH, and LUJ → 1.6L LXT,L2W → 2.0L Diesel LLW → LDE, LLU, LXV, 2H0, and LUW .
  5. Remove the radiator inlet hose. Refer to Radiator Inlet Hose Replacement : 2.0L Diesel LNP → LDD, LUH, and LUJ → 1.6L LXT,L2W → 2.0L Diesel LLW → LDE, LLU, LXV, 2H0, and LUW .
  6. Remove the transmission fluid auxiliary cooler pipe. Refer to Transmission Fluid Cooler Hose/Pipe Replacement .

    7. 2028322
  7. Disconnect the engine coolant fan resistor wiring harness plug (1) and remove the ground cable nut.
  8. Remove the wiring harness (3). Cut the 4 clips.

    9. 2191512

    Note: You stand against driving direction.

  9. Unclip the engine coolant fan shroud (1) at the shown four mounting points.
  10. Remove the engine coolant fan shroud (1).

Installation Procedure

    2191512
  1. Install the engine coolant fan shroud (1).
  2. Clip in the engine coolant fan shroud (1) at the shown four mounting points.

    3. 2028322
  3. Connect the engine coolant fan resistor wiring harness plug (1).
  4. Install the wiring harness (3). Install 4 NEW clips.

    5. Caution: Refer to Fastener Caution in the Preface section.

  5. Install the ground cable and the ground cable nut and tighten to 10 N·m (89 lb in).
  6. Install the transmission fluid auxiliary cooler pipe. Refer to Transmission Fluid Cooler Hose/Pipe Replacement
  7. Install the radiator inlet hose. Refer to Radiator Inlet Hose Replacement : 2.0L Diesel LNP → LDD, LUH, and LUJ → 1.6L LXT,L2W → 2.0L Diesel LLW → LDE, LLU, LXV, 2H0, and LUW .
  8. Install the radiator outlet hose. Refer to Radiator Outlet Hose Replacement : 2.0L Diesel LNP → LDD, LUH, and LUJ → 1.6L LXT,L2W → 2.0L Diesel LLW → LDE, LLU, LXV, 2H0, and LUW .
  9. Top up the cooling system. Refer to Cooling System Draining and Filling .
  10. Connect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
   


© Copyright Chevrolet. All rights reserved