Cruze

Crankshaft Balancer Replacement - MT - F17, M32

Special Tools

For equivalent regional tools, refer to Special Tools .

1. Open the bonnet.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
3. Remove the front compartment splash shield. Refer to Front Compartment Splash Shield Replacement .
4. Remove the drive belt. Refer to Drive Belt Replacement .
5. Remove the transmission front mount. Refer to Transmission Front Mount Replacement .



6. Remove the bolted connection (1).



7. Install the EN-6625 locking device (2) to lock the crankshaft.
8. Install the bolted connection (1).



9. Remove and DISCARD the crankshaft balancer bolt (1).
10. Remove the crankshaft balancer (2).

1. Install the crankshaft balancer (2).

Caution: Refer to Fastener Caution in the Preface section.

Caution: Refer to Torque-to-Yield Fastener Caution in the Preface section.

2. Install a NEW crankshaft balancer bolt (1) and tighten in 3 passes using the EN-45059 meter:

2.1.	First pass to 95 N·m (70 lb ft)

2.2.	Second pass to 45°.

2.3.	Third pass to 15°.




3. Remove the bolted connection (1).
4. Remove EN-6625 locking device (2) to unlock the crankshaft.



5. Install the bolted connection (1) and tighten to 40 N·m (30 lb ft).
6. Install the transmission front mount. Refer to Transmission Front Mount Replacement .
7. Install the drive belt. Refer to Drive Belt Replacement .
8. Install the front compartment splash shield. Refer to Front Compartment Splash Shield Replacement .
9. Lower the vehicle.
10. Close the bonnet.