Preliminary Procedures

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the front wheel and tire assembly. Refer to Tyre and Wheel Removal and Installation .

1

Stabilizer Shaft Link Ball Stud Nut

Caution: Refer to Fastener Caution in the Preface section.

Note: Use the proper size allen wrench to keep the stabilizer link ball stud from rotate while removing or installing the nut.

Tighten
65 N·m (48 lb ft)

2

Stabilizer Shaft Link Ball Stud Nut

Note: Use the proper size allen wrench to keep the stabilizer link ball stud from rotate while removing or installing the nut.

Tighten
110 N·m (81 lb ft)

3

Stabiliser Shaft Link