To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Remote Control Door Lock Receiver Replacement

Removal Procedure

    Warning: Refer to Battery Disconnect Warning in the Preface section.


    1763658
  1. Disconnect the negative battery cable.
  2. Remove the driver knee bolster. Refer to Driver Knee Bolster Replacement : Long Body  → Short Body .
  3. Remove the remote control door lock receiver.
  4. Disconnect the electrical connector.
  5. Perform the SPO reprogramming when RFA receiver is replaced.

Installation Procedure


    1763658
  1. Connect the electrical connector.
  2. Install the remote control door lock receiver.
  3. Install the driver knee bolster. Refer to Driver Knee Bolster Replacement : Long Body  → Short Body .
  4. Connect the negative battery cable.
  5. For set up and programming, refer to Control Module References .
   


© Copyright Chevrolet. All rights reserved