To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Windscreen Washer Solvent Container Filler Tube Replacement - Short Body


1877348

Callout

Component Name

Preliminary Procedure

Remove the left front headlamp assembly in order to access the filler neck at the washer container opening. Refer to Headlamp Replacement : Long Body  → Short Body .

1

Windscreen Washer Solvent Container Filler Tube Assembly Bolt

Caution: Refer to Fastener Caution in the Preface section.

Tighten
10 N·m (89 lb in)

2

Windscreen Washer Solvent Container Filler Tube Assembly

Procedure

  1. Reach into the driver side of the engine compartment at the position where the filler neck enters the windscreen washer container.
  2. Grasp the filler neck at the side of the front compartment front left hand panel where the filler tube enters the windscreen washer container.
  3. Twist the fill tube slightly back and forth while pulling outward from the container.
  4. Remove the filler tube.
  5. Inspect and replace any damaged O-ring.
  6. Use full strength windscreen washer fluid at the filler neck seal upon re-assembly.
  7. Aim the front headlamp assembly. Refer to Headlamp Aiming .
   


© Copyright Chevrolet. All rights reserved