To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Generator Replacement - LE5

Removal Procedure


    1578426
  1. Disconnect negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the drive belt. Refer to Drive Belt Replacement : LE5 or LE9 .
  3. Disconnect the generator electrical connector (1).
  4. Reposition the rubber boot (3).
  5. Remove the engine harness terminal lead to alternator nut (2).
  6. Remove the engine harness terminal (4) from the alternator stud.

  7. 2094845
  8. Remove the alternator fasteners (1,3, 4).
  9. Remove the generator.

Installation Procedure


    2094845
  1. Position the alternator to the engine block.
  2. Install the alternator fasteners (4) loosely.
  3. Caution: Refer to Fastener Caution in the Preface section.

  4. Install the fastener (1) and tighten to 10 N·m (89 lb in).
  5. Install the fastener (3) and tighten to 22 N·m (16 lb ft).
  6. Tighten the fasteners (4) to 22 N·m (16 lb ft).

  7. 1578426
  8. Install the engine harness terminal (4) to the alternator stud.
  9. Install the engine harness terminal lead to alternator nut (2) and tighten to 25 N·m (18 lb ft).
  10. Position the rubber boot (3) over the stud.
  11. Connect the alternator electrical connector (1).
  12. Install the drive belt. Refer to Drive Belt Replacement : LE5 or LE9 .
  13. Connect negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
   


© Copyright Chevrolet. All rights reserved