To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Headlamp Washer Nozzle Tube Replacement - Long Body


2243846

Callout

Component Name

Preliminary Procedures

  1. Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement : Long Body  → Short Body .
  2. Disengage the headlamp washer nozzle hole cover from the headlamp washer nozzle tube reinforcement.
  3. Remove the two washer nozzle screws.
  4. Remove the headlamp washer nozzle tube reinforcement.

1

Headlamp Washer Nozzle Tube Hole Cover

Tip
Use a flat-bladed tool in order to release the cover from the reinforcement.

2

Headlamp Washer Nozzle Reinforcement Screw (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
2.5 N·m (22 lb in)

3

Headlamp Washer Nozzle Tube Reinforcement

Tip
Remove from the front side of the front bumper fascia.

4

Headlamp Washer Nozzle Tube

Tip
Prime the headlamp washer nozzle tubes after replacement and inspect for leaks.

   


© Copyright Chevrolet. All rights reserved