To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Battery Tray Replacement

Removal Procedure


    1760937
  1. Remove the battery from the battery tray. Refer to Battery Replacement .
  2. Remove the engine control module (ECM). Refer to Engine Control Module Replacement : LE5, LE9 or LAF for the 2.4L engine, Engine Control Module Replacement for the 2.2L Diesel engine or Engine Control Module Replacement for the 3.0L engine.

  3. 1775338
  4. Remove the engine fuse block upper cover.
  5. Remove the engine fuse block retaining bolts.

  6. 2446741
  7. Remove the battery positive terminal (3) from the fuse block.

  8. 2243462
  9. Remove the engine fuse box from the lower cover.
  10. Remove the engine fuse block lower cover retaining nuts and release the tabs on the fuse block.

  11. 2485797
  12. Remove the glow plug controller mounting nut (1) at the expansion tank and set aside (if equipped).
  13. Remove connectors inside the fuse block.
  14. Disconnect the body harness connector to the engine harness connector.

  15. 2485781
  16. Remove the fuse block mounting nuts (1).

  17. 2485784
  18. Remove the air conditioner EVAP tube retainer bolt (1) at the battery tray.

  19. 1758653
  20. Remove the battery tray retaining bolts and detach the battery tray from the fuse block shield assembly support bracket.
  21. Remove the battery tray.

Installation Procedure


    1758653
  1. Install the battery tray.
  2. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the battery tray retaining bolts and tighten to 10 N·m (89 lb in).

  4. 2485781
  5. Install the fuse block shield assembly to the battery tray support bracket and welded studs. Tighten nuts (1) to 10 N·m (89 lb in).
  6. Route the body harness under the fuse block and connect it to the engine harness connector.
  7. Install the fuse block connectors.

  8. 2243462
  9. Install the engine fuse block and tighten the engine fuse block lower cover retaining bolts to 10 N·m (89 lb in).

  10. 1775338
  11. Install the engine fuse block retaining bolts and tighten to 3 N·m (27 lb in).
  12. Install the engine fuse block upper cover.

  13. 1760937
  14. Install the engine control module (ECM).Refer to Engine Control Module Replacement : LE5, LE9 or LAF for the 2.4L engine, Engine Control Module Replacement for the 2.2L Diesel engine or Engine Control Module Replacement for the 3.0L engine.

  15. 2485797
  16. Install the glow plug controller to the expansion tank and tighten the bolt (1) to 10 N·m (89 lb in) (if equipped).

  17. 2485784
  18. Install the air conditioner EVAP tube retainer bolt (1) to the battery tray and tighten to 10 N·m (89 lb in).

  19. 1775334
  20. Install the battery. Refer to Battery Replacement .
   


© Copyright Chevrolet. All rights reserved