To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Front Pipe Replacement - LNQ

Removal Procedure

Warning: Refer to Hot Exhaust System Warning in the Preface section.

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the underbody brace. Refer to Underbody Brace Replacement .
  3. Remove the engine shield. Refer to Engine Shield Replacement .

  4. 2480289
  5. Remove the exhaust particulate filter nuts (1).
  6. Discard the gasket (2).

  7. 2480290
  8. Remove the exhaust resonator nuts (1).
  9. Discard the gasket (2).

  10. 2480291
  11. Remove the front pipe from the exhaust isolator and remove from the vehicle.

Installation Procedure


    2480291
  1. Install the exhaust isolator rod into the exhaust isolator.
  2. Caution: Refer to Fastener Caution in the Preface section.


    2480290
  3. Install the front pipe to the exhaust resonator with a NEW gasket (2) and tighten the bolts (1) to 50 N·m (37 lb ft).
  4. Install the engine shield. Refer to Engine Shield Replacement .
  5. Install the underbody brace. Refer to Underbody Brace Replacement .
  6. Lower the vehicle.
  7. Start the engine and check for exhaust leaks.
   


© Copyright Chevrolet. All rights reserved