Preliminary Procedures

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the engine shield. Refer to Engine Shield Replacement .
3. Remove the left front wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement .

1

Left Front Wheel Drive Shaft Seal

Procedure

1. Remove the drive shaft oil seal with DT-23129 universal seal remover and DT-7004 slide hammer .
2. Coat the NEW drive shaft oil seal with transmission fluid.
3. Install the drive shaft oil seal using the DT-519 seal installer and hammer .

Note: Do not reuse the wheel drive shaft oil seal.

Special Tools

For equivalent regional tools, refer to Special Tools .