Captiva

Transmission Front Mount Replacement

Warning: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the engine protection shield. Refer to Engine Shield Replacement .
3. support the powertrain with a suitable jack stand.



4. Remove the front gearbox mount to frame bolt (1).



5. Remove the front transmission mount to transmission bolts (1).
6. Remove the front transmission mount (2).

1. Install the front transmission mount (2).

Caution: Refer to Fastener Caution in the Preface section.

2. Install the front transmission mount to transmission bolts (1) and tighten to 57 N·m (42 lb ft).



3. Install the front transmission mount to frame bolt (1) and tighten to 100 N·m (74 lb ft).
4. Remove the jack stand supporting the powertrain.
5. Install the engine protection shield. Refer to Engine Shield Replacement .
6. Lower the vehicle.