To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Front Side Door Outside Handle Replacement - Base

Removal Procedure


    2019726
  1. Remove the cover cap that conceals the screw (1) from the inside edge of the door.
  2. Using a small flat-bladed tool, release the cover cap from the door.


    2019727

    Note: The door outside handle (2) must now be secured in the pulled position.

  3. Remove the door handle from the door.
  4. 2.1. Pull the door handle (2) outwards and hold.
    2.2. Turn the fastener (1) counterclockwise ( left ) to the mechanical hard stop.

    2019728
    2.3. Remove the bezel with cylinder / cover with blank cylinder (1) from the door.

    2019729
  5. Remove the door handle (1) from the door as follows:
  6. 3.1. Slide the door handle rearward releasing it from the door handle bracket.
    3.2. Open the door handle fully.
    3.3. Remove the door handle from the door.

Installation Procedure


    2595975
  1. Install the door handle (1) to the door (2) as follows:
  2. 1.1. Insert the door handle into the door handle pocket.
    1.2. Slide the door handle forward securing it into the door handle bracket.

    2212931

    Note: The door handle will snap back to a flush condition, continue to turn the fastener in a clockwise ( right ) direction to the mechanical hard stop.

  3. Install the bezel with cylinder / cover with blank cylinder (1) in the door.
  4. Hold the bezel or cover flush to the door sheet and turn the cylinder clamp screw (2) to a mechanical hard stop.


    2019726
  5. Install the cover cap that conceals the screw (1) to the inside edge of the door.
  6. Ensure that the door lock system operates properly.
   


© Copyright Chevrolet. All rights reserved