To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Drive Motor Generator Rotor and Stator Removal - Unit B


2371935

Callout

Component Name

1

Drive Motor/Generator Power Inverter Module Cable Connector Bolt M6 x 20 mm (Qty: 3) - Internal

2

Auxiliary Pump Motor Cable Retainer - 3 Phase - Cable B/Resolver

3

Drive Motor/Generator Power Inverter Module Cable Stud M6 x 20 mm (Qty: 3) - External

Tip
Remove each cable individually after each bolt is removed.

4

Drive Motor/Generator Power Inverter Module Cable Assembly - 3 Phase - B

5

Drive Motor/Generator Power Inverter Module Cable Assembly Seal - 3 Phase (Qty: 3)

Tip
Discard seal, it is not reusable.

6

Drive Motor/Generator Power Inverter Module Cable Housing Cover Seal

Tip
Discard seal, it is not reusable.

7

Drive Motor/Generator Stator Bolt M6 x 20 mm (Qty: 4)

8

Drive Motor/Generator Stator Assembly - Unit B

Warning: The generator motor weighs approximately 36 kg (80 lbs). Personal injury may result if you lift the generator motor improperly.

Tip
The shell and or gear set may slip out of the case while removing the drive motor.

Special Tools

DT 50302 Rotor and Stator Lifter Assembly

For equivalent regional tools, refer to Special Tools .

   


© Copyright Chevrolet. All rights reserved