Preliminary Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tyre and wheel assembly. Refer to Tyre and Wheel Removal and Installation .
3. Remove the wheel speed sensor. Refer to Front Wheel Speed Sensor Replacement .
4. Remove the front brake rotor. Refer to Front Brake Disc Replacement .
5. Remove the wheel drive shaft nut from the wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement .

1

Front Wheel Hub Bolt (Qty: 3)

Warning: Refer to Torque-to-Yield Fastener Warning in the Preface section.

Caution: Refer to Fastener Caution in the Preface section.

Procedure

Remove and discard the bolt and replace with NEW only.

Tighten

1. First Pass: 100 N·m (74 lb ft).
2. Final Pass: additional 60 degrees.

2

Front Wheel Hub.

3

Front Brake Shield