To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Wheel Stud Replacement


2451086

Callout

Component Name

Preliminary Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tyre and wheel assembly. Refer to Tyre and Wheel Removal and Installation .
  3. Remove the front wheel bearing and hub. Front Wheel Bearing and Hub Replacement .

1

Wheel Stud (Qty: 5)

Procedure

  1. Rotate the wheel hub so that the wheel stud to be removed is located where the front brake caliper mounts to the knuckle.
  2. Using the CH 43631 remover, remove and discard the wheel stud from the wheel hub. Replace with NEW only.
  3. When installing the wheel stud, use the proper amount of washers to allow the wheel stud to be fully seated against the wheel bearing flange.
  4. Use a wheel nut with the flat side of the wheel nut facing the washers to fully seat the wheel stud.

Special Tools

CH 43631 Ball Joint Remover

For equivalent regional tools, refer to Special Tools

   


© Copyright Chevrolet. All rights reserved