To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Electronic Hand brake Control Module Replacement

Removal Procedure

  1. Place the transmission in PARK.
  2. Disable the hand brake cable adjuster. Refer to Hand brake Cable Adjuster Disabling .
  3. Place the power button in the OFF position.
  4. Danger: Do not use a service jack in locations other than those specified to lift this vehicle. Lifting the vehicle with a jack in those other locations could cause the vehicle to slip off the jack and roll; this could cause injury or death.

  5. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  6. Remove the left rear tyre and wheel assembly. Refer to Tyre and Wheel Removal and Installation .
  7. Remove the left rear wheelhouse panel liner. Refer to Rear Wheelhouse Panel Liner Replacement .

  8. 2391020
  9. Remove the hand brake cable nut (1) from the electronic hand brake control module.
  10. Disconnect the electronic hand brake control module electrical connector.

  11. 2391024
  12. Remove the electronic hand brake control module nuts (1).

  13. 2391027
  14. Lower the front of the electronic hand brake control module (1) and release the module from the grommet in the vehicle body.
  15. Remove the electronic hand brake control module.

Installation Procedure


    2391027
  1. Insert the electronic hand brake control module (1) hanger into the grommet in the vehicle body.
  2. Raise the front of the electronic hand brake control module and install onto the studs in the vehicle body.
  3. Caution: Refer to Fastener Caution in the Preface section.


    2391024
  4. Install the electronic hand brake control module nuts (1) and tighten to 10 N·m (89 lb in).
  5. Connect the electronic hand brake control module electrical connector.

  6. 2391020
  7. Install the hand brake cable nut (1) to the electronic hand brake control module and tighten to 6 N·m (53 lb in).
  8. Install the left rear wheelhouse panel liner. Refer to Rear Wheelhouse Panel Liner Replacement .
  9. Install the left rear tyre and wheel assembly. Refer to Tyre and Wheel Removal and Installation .
  10. Enable the hand brake cable adjuster. Refer to Hand brake Cable Adjuster Enabling .
  11. Program the electronic hand brake control module. Refer to Electronic Hand brake Control Module Programming and Setup
   


© Copyright Chevrolet. All rights reserved