To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Charge Port Door Hinge Bezel Replacement


2392962

Callout

Component Name

Danger: Always perform the High-Voltage Disabling procedure prior to servicing any High Voltage component or connection. Personal Protection Equipment (PPE) and proper procedures must be followed.

The High-Voltage Disabling procedure will perform the following tasks:

   • Identify how to disable high voltage.
   • Identify how to test for the presence of high voltage.
   • Identify conditions under which high voltage is always present and personal protection equipment (PPE) and proper procedures must be followed.
Before working on any high-voltage system, be sure to wear the following Personal Protection Equipment:
   • Safety goggles with appropriate side shields when within 15 metres (50 feet) of the vehicle, either indoors or outdoors.
   • Certified and up-to-date Class "0" Insulation gloves rated at 1000 V with leather protectors.
      - Visually and functionally inspect the gloves before use.
      - Wear the Insulation gloves with leather protectors at all times when working with the high-voltage battery assembly, whether the system is energised or not.
Failure to follow the procedures exactly as written may result in serious injury or death.

Danger: The Volt Battery Pack will utilise an exchange program. Please consult the most recent revision of bulletin/PI #PIP4841, available in Service Information (SI), for a list of approved Volt Battery Pack service procedures. Components that may be removed and serviced without exchanging the complete battery pack are identified in the bulletin/PI. Please contact the GM Technical Assistance Centre (1-877-446-8227) if you have any questions.

Preliminary Procedures

  1. Remove the charge port door. Refer to Charge Port Door Replacement .
  2. Disable the high-voltage system. Refer to High Voltage Disabling .

1

Charge Port Hinge Bezel

Procedure

  1. Release the four tabs from the backside of the hinge and remove the charge port hinge bezel.
  2. Enable the high-voltage system. Refer to High-Voltage Enabling .
   


&#169© Copyright Chevrolet. All rights reserved