To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Master Cylinder Reservoir Replacement

Removal Procedure

Warning: Refer to Brake Fluid Irritant Warning in the Preface section.

Caution: Refer to Brake Fluid Effects on Paint and Electrical Components Caution in the Preface section.

  1. Remove the front suspension strut housing brace. Refer to Front Suspension Strut Housing Brace Replacement .

  2. 2384687
  3. Remove the brake master cylinder reservoir bolts (1).

  4. 2384689
  5. Carefully pull the master cylinder reservoir (1) straight upward and remove the master cylinder reservoir from the master cylinder.

  6. 2384691
  7. Remove and discard the brake master cylinder reservoir seals (1).

Installation Procedure

  1. Lightly lubricate the master cylinder reservoir seals with GM approved brake fluid from a clean, sealed brake fluid container. Refer to Adhesives, Fluids, Lubricants, and Sealers .

  2. 2384691
  3. Install the brake master cylinder reservoir seals (1).

  4. 2384689
  5. Carefully install the master cylinder reservoir (1) to the master cylinder.
  6. Caution: Refer to Fastener Caution in the Preface section.


    2384687
  7. Install the brake master cylinder reservoir bolts (1) and tighten to 8 N·m (71 lb in).
  8. Install the front suspension strut housing brace. Refer to Front Suspension Strut Housing Brace Replacement .
   


© Copyright Chevrolet. All rights reserved