To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Range Selector Lever Cable Bracket Replacement

Removal Procedure

    Danger: Always perform the High Voltage Disabling procedure prior to servicing any High Voltage component or connection. Personal Protection Equipment (PPE) and proper procedures must be followed.

    The High Voltage Disabling procedure will perform the following tasks:

       • Identify how to disable high voltage.
       • Identify how to test for the presence of high voltage.
       • Identify condition under which high voltage is always present and personal protection equipment (PPE) and proper procedures must be followed.
    Failure to follow the procedures exactly as written may result in serious injury or death.

  1. Disable the hybrid high voltage system. Refer to High Voltage Disabling .
  2. Remove the drive motor generator power inverter module from the vehicle. Refer to Drive Motor Generator Power Inverter Module Replacement .

  3. 2388982
  4. Disconnect the transmission range selector lever cable terminal (1) from the transmission manual gear shift lever pin.

  5. 2388980
  6. Press the locking tab (1) rearward in order to release the transmission range selector lever cable (2) from the cable bracket.

  7. 2395418
  8. Remove the shift control cable bracket bolts (1).
  9. Remove the shift control cable bracket (2).

Installation Procedure

    Caution: Refer to Fastener Caution in the Preface section.

  1. Install the transaxle shift control bracket and bolts, then tighten the bolts to 22 N·m (16 lb ft).

  2. 2388980
  3. Install the transmission range selector lever cable (2) to the cable bracket.
  4. Press the locking tab (1) forward in order to retain the transmission range selector lever cable (2) to the cable bracket (3).

  5. 2388982
  6. Connect the transmission range selector lever cable terminal (1) to the transmission manual gear shift lever pin.
  7. Check the range selector cable adjustment. Refer to Range Selector Lever Cable Adjustment .
  8. Install the drive motor generator power inverter module in the vehicle. Refer to Drive Motor Generator Power Inverter Module Replacement .
  9. Enable the hybrid high voltage system. Refer to High Voltage Enabling .
   


&#169© Copyright Chevrolet. All rights reserved