Callout
| Component Name
|
Preliminary Procedures
- Remove the camshaft cover. Refer to Camshaft Cover Replacement .
- Remove both camshaft position actuator solenoid valves. Refer to
Camshaft Position Actuator Solenoid Valve Replacement : Exhaust → Intake .
- Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
- Set the crankshaft to TDC. Refer to Camshaft Timing Chain Inspection
- Install the engine support fixture. Refer to Engine Support Fixture .
- Remove the water pump pulley and the water pump. Refer to Water Pump Replacement .
- Remove the sump. Refer to Sump Replacement .
|
1
| Engine Front Cover with Oil Pump Fastener (Qty: 13)
Caution: Refer to Fastener Caution in the Preface section. ProcedureEnsure to mark the location of each bolt.
Tighten 8 N·m (71 lb in) |
2
| Engine Front Cover with Oil Pump Fastener (Qty: 2)
Tighten 35 N·m (26 lb ft) |
3
| Engine Front Cover with Oil Pump Gasket
Procedure
- Remove the camshaft timing chain out of the way before removing the engine front cover gasket. Refer to Camshaft Timing Chain Replacement .
- Replace the engine front cover gasket whenever the cover is removed.
- Adjust timing chain on installation. Refer to Camshaft Timing Chain Adjustment
Tip Removal of timing chain is necessary to get access to engine front cover gasket. |
4
| Engine Front Cover RTV Sealant
ProcedureApply a 2 mm (0.0787 in) bead of RTV sealant to the areas shown (3).
|
5
| Engine Front Cover with Oil Pump
Procedure
- To disassemble oil pump, refer to Engine Front Cover and Oil Pump Disassemble .
- For cleaning and inspection of the oil pump, refer to Engine Front Cover and Oil Pump Cleaning and Inspection .
- Reposition coolant hoses as necessary.
- Disconnect electrical connector as necessary.
- Transfer components as necessary.
|