To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Camshaft Timing Chain Replacement

Special Tools

EN-955-1 Locking Pin

For equivalent regional tools, refer to Special Tools .

Removal Procedure

  1. Remove the engine front cover. Refer to Engine Front Cover with Oil Pump Replacement .

  2. 2190679
  3. Push the timing chain (2) in direction to the timing chain tensioner (1) and install the EN-955-1 pin (3).

  4. 2190676
  5. Remove the two upper timing chain guide bolts (1).
  6. Remove the upper timing chain guide (2).

  7. 2190677
  8. Remove the two timing chain guide right side bolts (2).
  9. Remove the timing chain guide right side (1).

  10. 2190678
  11. Remove the timing chain tensioner shoe bolt (2).
  12. Remove the timing chain tensioner shoe (1).

  13. 2190675
  14. Remove the timing chain (1) and crankshaft sprocket (2) together as a unit.

  15. 2190693
  16. Remove the engine front cover gasket (1).

Installation Procedure

  1. Clean the engine front cover sealing surfaces on engine block and cylinder head.

  2. 2190694
  3. Apply a 2 mm (0.0787 in) bead of RTV sealant the areas shown above (1, 2).

  4. 2190693
  5. Install the engine front cover gasket (1).

  6. 2190675
  7. Install the timing chain (1) and crankshaft sprocket (2) together as a unit.

  8. 2190678
  9. Install the timing chain tensioner shoe (1).
  10. Caution: Refer to Fastener Caution in the Preface section.

  11. Install the timing chain tensioner shoe bolt (2) and tighten to 20 N·m (15 lb ft).

  12. 2190677
  13. Install the timing chain guide right side (1).
  14. Install the timing chain guide right side bolts (2) and tighten to 8 N·m (71 lb in).

  15. 2190679
  16. Push the timing chain (2) in direction of the timing chain tensioner (1) and remove EN-955-1 pin (3).
  17. Install the engine front cover. Refer to Engine Front Cover with Oil Pump Replacement .
   


© Copyright Chevrolet. All rights reserved