To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Quarter Inner Trim Finish Panel Replacement


2405026

Callout

Component Name

Preliminary Procedures

  1. Remove the rear side door opening floor carpet retainer. Refer to Rear Side Door Opening Floor Carpet Retainer Replacement .
  2. Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement .
  3. Remove rear seat back. Refer to Rear Seat Back Cushion Replacement .
  4. Remove the body lock pillar upper trim panel. Refer to Body Lock Pillar Upper Trim Panel Replacement .
  5. Remove the rear compartment floor panel trim. Refer to Rear Compartment Floor Panel Trim Replacement .
  6. Remove the rear compartment floor stowage trim compartment. Refer to Rear Compartment Floor Stowage Trim Compartment Replacement .
  7. Remove the rear end trim finish panel. Refer to Rear End Trim Finish Panel Replacement .
  8. Reposition the rear shoulder belt around the panel and through the opening in the panel. Refer to Shoulder Belt Replacement - Rear .

1

Quarter Inner Trim Finish Panel Fastener

Caution: Refer to Fastener Caution in the Preface section.

2

Convenience Net Upper Retainer

3

Cargo Screen Retainer Assembly (Qty: 2)

Procedure

  1. Turn the left front and right rear cargo screen retainer anticlockwise one quarter turn to disengage the 2 integral tabs.
  2. Turn the left rear and right front cargo screen retainer clockwise one quarter turn to disengage the 2 integral tabs.

4

Quarter Inner Trim Finish Panel

Procedure

  1. Use a trim tool or equivalent to aid in removal.
  2. Remove the quarter trim panel cover.
  3. Disconnect the electrical connector, if necessary.

Tip
After installation of the quarter inner trim panel, ensure the rear seat belt is not trapped under the trim panel. Pull up on the belt to verify full movement of the belt.

   


© Copyright Chevrolet. All rights reserved