To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Generator Control Module Coolant Pump Replacement


2420478

Callout

Component Name

Danger: Do not use a service jack in locations other than those specified to lift this vehicle. Lifting the vehicle with a jack in those other locations could cause the vehicle to slip off the jack and roll; this could cause injury or death.

Preliminary Procedure

  1. Drain the coolant. Refer to Drive Motor Generator Power Inverter Module Cooling System Draining and Filling
  2. Remove the front wheelhouse front liner on the driver's side. Refer to Front Wheelhouse Front Liner Replacement
  3. Remove the drive motor generator control module coolant pump hose. Refer to Drive Motor Generator Control Module Coolant Pump Hose Replacement
  4. Remove the drive motor generator control module cooling outlet hose. Refer to Drive Motor Generator Control Module Cooling Outlet Hose Replacement

1

Generator Control Module Coolant Pump Bolts (Qty: 2).

Caution: Refer to Fastener Caution in the Preface section.

Tighten
9 N·m (80 lb in)

2

Generator Control Module Coolant Pump.

   


© Copyright Chevrolet. All rights reserved